ALDI Ferrex 809147, Руководство пользователя

Страница: 15 / 22

Operation
CAUTION!
Risk of injury!
A damaged device or damaged accessories can lead to injuries.
- Check the device and the accessories (see section "Testing").
This chapter describes how to operate the device. The following instructions for use
serve for your own safety and for successful, safe use of the device.
General information for the battery and charger
■
Only use suitable batteries (see chapter "Technical Data") and chargers
approved by the manufacturer.
■
The device has undervoltage detection. If the battery is empty, the device
switches off.
■
Read and follow the instructions in the operating manuals of the battery and
charger used.
■
To charge the battery, follow the instructions in the operating manuals of the
battery and charger you are using.
■
The battery must not be inserted before you make device settings, change tool
insert parts or put the power tool away.
During a work break you can clip the device 1 to your belt by using
the belt-clip 2 .
Inserting bits
1. Hold the bit support 5 between
your thumb and finger and pull it
towards the device.
2. Insert a bit into the bit holder as far
as possible.
3. Release the bit support.
The bit is inserted.
Insert / Remove Battery
Changing the battery corresponds to the sequence of removing the battery followed
by inserting the battery.
1
5
Operation
15