Safety Guidelines
Before proceeding with the installation or operation of this product,
read all instructions thoroughly, as well as complying with all federal,
state and local codes, regulations, and practices. This product must
be installed by qualified personnel familiar with all applicable local
electrical and mechanical codes. Refer to the National Electrical Code
(NFPA 70). Failure to properly install and test this product can result in
personal injury or equipment malfunction.
WARNING
Step 1: 9VDC Battery Backup
Step 2: Mounting Alarm Panel
Step 3: Mounting Alarm Panel
(continued)
Step 1A: To install or replace the battery for the backup power feature,
remove the alarm panel access cover.
Step 1B: Install the 9VDC battery matching the terminals of the wire
connector on the alarm panel to the terminals on top of the battery.
Place the battery inside the top panel compartment to secure and
ensure proper operation of the backup power feature.
1A
1B
Determine mounting location for the alarm panel, make sure the power
outlet (120VAC, 50/60 Hz) is within five feet (5′) of the alarm panel. The
power outlet should be on a separate circuit breaker from any other
device and not on a switched receptacle to maintain power integrity.
CAUTION:
Do not connect power to the alarm panel until the
installation of both the Sump Advisor™ alarm panel and Sump Advisor™
sensor are completed.
5 Feet Maximum
To mount the alarm panel, hold in the desired mounting location and
mark the drill hole locations. Once marked, drill pilot holes for screws (not
included) and use wall mount anchors (not included) if necessary. Place
alarm panel in the mounting location, adjust until the pilot holes are lined
up with the enclosure and fasten screws to secure the alarm panel in place.
QUICK START GUIDE
Sump Advisor
™
2-Zone Alarm and Sensor
Rated Type 1, Indoor Alarm Panel (use with Alderon™ VertiMAC™ series)
Q
SG
00
01
9_
Re
v0
4_
Su
m
p A
dv
iso
r 2
-Z
on
e A
la
rm P
an
el a
nd S
en
so
r | N
ov
em
be
r 2
5, 2
02
0 1
:4
3 P
M
2000514 2000558 2000559 2000560 2000561
Alderon Industries™
Pat. No. 10,794,379
