1. Place table top
1
upside down on level surface.
2. Ensure the release rod (not shown, inside column) is fully
inside the column
2
, then insert the column tongue into
the table top bracket
5
as shown at right. Align the tongue
and bracket holes. Insert — but do not tighten
— the two Phillips screws
6
and washers
6
as shown
through bracket into tongue.
3. Position the release lever
3
as shown, with curved side
facing table top, and install in column. Match the release
lever and bracket alignment holes, then insert hex bolt
4
through both to secure release lever to bracket. Install hex
nut
4
on bolt. Use two M6 wrenches to tighten. Use a
Phillips screwdriver to now tighten the Phillips screws
6
that secure bracket to tongue.
Note: The most current version of these instructions can be found online
at
www.alcosales.com
Tools needed: Phillips screwdriver,
5
/
8
wrench, two M6 wrenches (you may wish to use appropriate socket or
adjustable wrenches instead)
1
AL-82995: OVERBED TABLE, STANDARD
NON-TILT ASSEMBLY & OPERATION
INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before assembling or using the AL-82995
Overbed Table. If you do not understand any part of these instructions, contact a healthcare professional
for direction in the use of this product. If the overbed table is not properly assembled and adjusted,
personal injury and/or damage to the overbed table could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use
substitute parts.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This product
contains a chemical known to the State of California to cause cancer and reproductive or
developmental harm.
WARNING: ALCO Sales & Service Co. assumes no responsibility for any damage or injury caused by
improper assembly or use of this product.
ASSEMBLY INSTRUCTIONS
Unpacking
1. Open end of box.
2. Slide contents out of box.
3. Collect base, table top, column, and hardware.
Assembly (see picture at right)
WARNING: Do not remove the black
screw
13
from the column
2
before the table is
completely assembled and in upright position; the
table top could rise suddenly and cause serious
personal injury.
WARNING: The column is spring-loaded — DO NOT
disassemble the column; this could cause serious
personal injury.
4. Note orientation of base caster holes, facing away
from table top as shown, and place the base
7
above the column. Install the two large hex bolts
12
through the
bolt plate
11
, bolt sleeves
10
, base, and into the end of the column as shown. Use a 5/8 wrench to tighten the
bolts.
5. Install the casters
8
and
9
as shown: press the casters in until they lock into place.
6. TURN THE TABLE UPRIGHT and place it on the floor. Use a Phillips screwdriver to remove the black screw
13
;
discard it and replace it with the chrome screw
14
. Use a Phillips screwdriver to tighten the screw.
7. Remove protective film from table top surface.
WARNING: Ensure that the table is assembled as described, and that all components are securely
attached, before use.
Assembly
alignment hole
tongue
release
lever
3
hex bolt
4
hex nut
4
chrome hex head screw —
DO NOT remove
Phillips screw
(2 each)
6
washer
(2 each)
6
bolt sleeve
(2 each)
10
bolt plate
11
large hex bolt
(2 each)
12
non-locking caster
(2 each)
9
bracket
5
table top
1
column
2
locking caster (2 each)
8
base
7
black screw — DO NOT remove from column
before table is completely assembled and in
upright position
13
