Network Interface (NI) Modules
GNI Modules
OmniSwitch 8800 Hardware Users Guide
December 2004
page 5-15
Removing MiniGBIC Connectors
MiniGBICs modules can be hot swapped. You are not required to power off the switch before removing a
MiniGBIC from an OS8-GNI-U8 or OS8-GNI-U24 module. To remove a Miniature Gigabit Interface
Converter (MiniGBIC) follow the steps below.
Note.
Before handling any components, free yourself of static by wearing a grounding strap, or by ground-
ing yourself properly. Static discharge can damage the MiniGBIC, as well as the Gigabit Ethernet fiber
module. Refer to
“Using the Grounding Wrist Strap and Chassis Grounding Lug” on page 5-29
for more
information.
1
Remove any LC cables from the MiniGBIC.
2
To remove a MiniGBIC you must first open the MiniGBIC’s hinged face to approximately ninety
degrees. Then, grasp the hinged face and carefully pull the MiniGBIC straight out of the slot
3
Slide the MiniGBIC out of the module’s port.
4
Store the MiniGBIC in a secure, static-free location. Placing the MiniGBIC in an anti-static bag is
recommended.
C T
LINK
A C
T
LINK
A C
T
8
