Chassis and Power Supplies
Power Cords
OmniSwitch 7700/7800 Hardware Users Guide
April 2005
page 2-27
Power Cords
Because the power cord is the power supply’s main disconnect device, it should be plugged into an easily
accessible outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Specifications
The power cord to be used with 115-Volt configuration is a minimum type SJT (SVT) 14/3, rated at 250
Volts AC, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug
and the other end terminates in a NEMA 5-15P plug.
The power cord to be used with 230-Volt configuration is minimum type SJT (SVT) 14/3, rated 250 Volts
ac, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug and
the other end terminates as required by the country where it will be installed.
European cords must be Harmonized (HAR) type.
Important.
The specified replacement power cord for OmniSwitch 7700/7800 switches is 14-gauge
(14/3). Do not use standard 18-gauge (18/3) cords such as those supplied with personal computers.
DC-to-DC Power Cords
For DC-to-DC connections, refer to
for additional guidelines and information.
