Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 992 / 2018

LINK OAM Commands
page 26-24 OmniSwitch 6250 CLI Reference Guide November 2009
efm-oam port l1-ping
Configures the number of frames to be sent by the current LINK OAM port to the remote port’s MAC
address (l1 ping) and the delay between each consecutive sent frames and to start the ping operation.
efm-oam port slot/port l1-ping [num-frames number] [delay milliseconds] [start]
Syntax Definitions
slot/port Specifies the slot number for the module and the physical port number
on that module (e.g. 3/1 specifies port 1 on slot 3).
number Specifies the number of frames that needs to be sent during ping opera-
tion. The allowed range of numbers is between 1 to 20.
milliseconds Specifies time interval between two consecutive PDUs. The allowed
range of delay is between 100 to 1000 milliseconds.
start Specifies to start the ping operation.
Defaults
Platforms Supported
OmniSwitch 6250.
Usage Guidelines
•
The command is valid only when the LINK OAM is enabled globally, port is in active mode, discov-
ery is done, and the port is in remote loopback mode.
•
L1 ping can be started only when the port is in remote loopback mode.
Examples
-> efm-oam port 1/12 l1-ping num-frames 6 delay 300 start
-> efm-oam port 1/20 l1-ping num-frames 12 delay 500 start
-> efm-oam port 1/15 l1-ping num-frames 5 delay 100 start
-> efm-oam port 1/15 l1-ping num-frames 4 delay 200 start
-> efm-oam port 1/5 l1-ping num-frames 100 delay 300 start
Release History
Release 6.6.1; command was introduced.
parameter default
number 5 frames
milliseconds 1000 milliseconds