Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 866 / 2018

VLAN Stacking Commands
page 24-4 OmniSwitch CLI Reference Guide November 2009
ethernet-service source-learning
Configures the status of source learning on a VLAN Stacking VLAN (SVLAN) used for tunneling
customer traffic or on an SVLAN that the IP Multicast VLAN (IPMV) application uses to
distribute multicast network traffic.
ethernet-service {svlan | ipmvlan} svid1[-svid2] source-learning {enable| disable}
Syntax Definitions
svlan Specifies an SVLAN for tunneling customer traffic.
ipmvlan Specifies an SVLAN used by IP Multicast VLAN to distribute
multicast traffic.
svid1 The VLAN ID number identifying the SVLAN (2–4094).
-svid2 The last VLAN ID number in a range of SVLANs that you want to
configure (e.g. 10-12 specifies SVLANs 10, 11, and 12).
enable Enables source MAC address learning.
disable Disables source MAC address learning.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
By default, source MAC address learning is enabled on all the SVLANs.
•
Disabling source learning on an SVLAN clears all the dynamically learned MAC addresses associated
with the VLAN from the MAC address table.
•
Static MAC addresses associated with an SVLAN are not cleared when source learning is disabled for
the SVLAN.
•
Configuring the source learning status is not supported on Management SVLANs.
Examples
-> ethernet-service svlan 120-150 source-learning disable
-> ethernet-service ipmvlan 320-350 source-learning disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable enable