Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 345 / 2018

Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-7
static agg agg num
Configures a slot and port for a static aggregate group.
static agg [ethernet | fastethernet | gigaethernet] slot/port agg num agg_num
static agg no [ethernet | fastethernet | gigaethernet] slot/port
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
agg_num The number corresponding to the static aggregate group.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove one or more ports from a static aggregate group.
•
Mobile ports cannot be aggregated.
•
A port may belong to only one aggregate group.
•
Ports in a static aggregate must all be the same speed (e.g., all 10 Mbps, all 100 Mbps, all 1 Gigabit, or
all 10 Gigabit).
•
Ports that belong to the same static aggregate group do not have to be configured sequentially and can
be on any Network Interface (NI) or unit within a stack.
•
The ethernet , fastethernet , and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet
ports.
Examples
-> static agg 2/1 agg num 4
-> static agg no 2/1