Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 231 / 2018

File Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 7-19
cp
Copies an existing file. This command can also copy a directory if the -r keyword is used.
cp [-r] [path/]orig_filename [dest_path/]dupl_filename
Syntax Definitions
-r Syntax that recursively copies directories, as well as any associated
subdirectories and files. Be sure to include a space between the syntax
cp and -r (i.e., cp -r ).
path/ Specifies the path containing the original file to be copied. If no path
name is specified, the command assumes the current path.
orig_filename The name of the existing file to be copied.
dest_path/ Specifies the destination path for the resulting file copy. If no destina-
tion path is specified, the file copy will be placed in the current path.
dupl_filename The new user-defined file name for the resulting file copy. If you are
copying a file to the same directory as the original, the file name for the
copy must be different from the original. Up to thirty-two (32) charac-
ters may be used.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
You should verify that your switch’s /flash directory has enough available memory to hold the new
files and directories that will result from using the cp -r command.
•
A file may be copied to a new location; you are not required to copy a file to the same directory that
contains the original.
•
Be sure to separate path directories and file names with a slash (/). Refer to the examples below.
•
Up to 255 characters may be used for a fully qualified path.
•
A path can contain up to a maximum of seven (7) directories including /flash .
•
As with files names, up to thirty-two (32) characters may be used for a directory name.
•
File and directory names can include only the following character types: a-z, A-Z, 0-9, dashes (-),
dots (.), and underscores (_).
•
This command can also be used on the secondary CMM.