Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 1933 / 2018

802.1X Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 44-7
802.1x supp-polling retry
Configures the number of times to poll a device for EAP frames to determine whether or not the device is
an 802.1x client.
802.1x slot/port supp-polling retry retries
Syntax Definitions
slot The slot number of the 802.1x port.
port The 802.1x port number.
retries The number of times a device is polled for EAP frames (0–99).
Defaults
By default, the number of retries is set to 2.
Platforms Supported
OmniSwitch 6250
Usage Guideline
•
The polling interval is 0.5 seconds between each retry.
•
If no EAP frames are received from a device connected to an 802.1x port, the device is considered a
non-802.1x client (non-supplicant).
•
Specify 0 for the number of retries to bypass polling attempts and automatically classify the device
connected to the 802.1x port as a non-supplicant.
•
Any devices previously authenticated on the port remain authenticated; however, re-authentication will
not occur.
•
If a guest VLAN is configured on the 802.1x port, the non-802.1x client is assigned to the guest
VLAN. If a guest VLAN does not exist, the device is blocked from accessing the 802.1x port.
Examples
-> 802.1x 3/1 supp-polling retry 5
-> 802.1x 3/9 supp-polling retry 10
-> 802.1x 2/1 supp-polling retry 0
Release History
Release 6.6.1; command was introduced.