Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 1507 / 2018

QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-11
policy network group
Configures a network group name and its associated IP addresses. The group may be used as part of a
policy condition. The action associated with any policy using the condition will be applied to all members
of the network group.
policy network group net_group ip_address [mask net_mask] [ip_address2 [mask net_mask2]...]
no policy network group net_group
policy network group net_group no ip_address [mask netmask] [ip_address2 [mask net_mask2]...]
Syntax Definitions
net_group The name of the network group (up to 31 alphanumeric characters).
ip_address An IPv4 address included in the network group. IPv6 addresses are not
supported with network groups.
net_mask The mask for the IPv4 address. If no mask is entered, the IPv4 address
is assumed to be a host address.
ip_address2 Optional. Another IPv4 address to be included in the network group.
Multiple IP addresses may be configured for a network group. Separate
each address/mask combination with a space.
net_mask2 Optional mask for the IPv4 address. If no mask is entered, the natural
mask for the address will be used.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to configure a group of IPv4 addresses to which you want to apply QoS rules.
Rather than create a condition for each IPv4 address, group the addresses together. Use the
policy
condition command to associate a condition with the network group.
•
Use the no form of the command to remove a network group from the configuration, or to remove an
IP address from a network group.
•
If the snapshot command is entered after the policy network group command is configured, the
resulting ASCII file will include the following additional syntax for the policy network group
command:
from {cli | ldap | blt}
This syntax indicates how the network group was created. The cli and ldap options may be changed by
a user modifying the ASCII file; however, changing this setting is not recommended. The blt option
indicates a built-in network group, this setting is not configurable.