Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 1271 / 2018

RDP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 31-15
show ip router-discovery
Displays the current RDP status and related statistics for the entire switch.
show ip router-discovery
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Each time RDP is enabled on the switch, all statistic parameter values are reset to zero for the new
session. For example, if the RDP uptime was 160000 seconds when RDP was last disabled, the uptime
starts out at zero the next time RDP is enabled.
•
Use the show ip router-discovery interface command to display information about a specific RDP
interface.
Examples
-> show ip router-discovery
Status = Enabled,
RDP uptime = 161636 secs
#Packets Tx = 4,
#Packets Rx = 0,
#Send Errors = 0,
#Recv Errors = 0,
output definitions
Status The status of RDP. Enabled allows RDP interfaces to advertise router
IP addresses; Disabled stops RDP traffic on all switch interfaces. Use
the ip router-discovery command to enable or disable RDP on the
switch.
RDP uptime Indicates the amount of time, in seconds, that RDP has remained active
on the switch.
#Packets Tx The number of RDP packets transmitted from all active RDP interfaces
on the switch.
#Packets Rx The number of RDP packets received on all active RDP interfaces on
the switch.
#Send Errors The number of RDP packet transmission errors that have occurred.
#Recv Errors The number of errors that occurred when receiving RDP packets.