Alcatel-Lucent OmniSwitch 6250, Справочное руководство CLI, Страница: 1038 / 2018

Port Mapping Commands
page 28-2 OmniSwitch 6250 CLI Reference Guide November 2009
port mapping user-port network-port
Creates a port mapping session either with or without the user ports, network ports, or both. Use the no
form of the command to delete ports or an aggregate from a session.
port mapping port_mapping_sessionid [no] [user-port {slot slot | slot/port[-port2] | linkagg agg_num}]
[network-port {slot slot | slot / port[-port2] | linkagg agg_num}]
Syntax Definitions
port_mapping_sessionid The port mapping session ID. Valid range is 1 to 8.
user-port Specifies a user port of the mapping session.
network-port Specifies a network port of the mapping session.
slot Specifies a slot to be assigned to the mapping session.
slot Slot number you want to configure.
port Port number you want to configure.
port2 Last port number in a range of ports you want to configure.
linkagg Specifies a link aggregation group to be assigned to the mapping
session.
agg_num Link aggregation number.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
User ports that are part of one session cannot communicate with each other and can communicate only
via network ports of the session to the rest of the system.
•
User ports can be part of one Port Mapping session only.
•
An aggregable port of a link aggregation group cannot be a mapped port and a mapped port cannot be
an aggregable port of a link aggregation group.
•
A mirrored port cannot be a mapped port and a mapped port cannot be a mirrored port.
•
A mobile port cannot be configured as a network port of a mapping session.