Alcatel-Lucent OmniAccess SafeGuard, Руководство по установке

Страница: 44 / 52

OmniAccess SafeGuard Controller Installation Guide
44
Appendix B: Safety and Regulatory Compliance
immediate failure, or it can show up as a latent failure affecting the reliability of the
equipment.
To minimize the likelihood of ESD damage to the SafeGuard Controller, follow these
guidelines when you are handling the SafeGuard Controller or SFP modules:
■
Always use an antistatic wrist strap or other antistatic device.
To use the disposable ESD wrist strap that is provided, put the strap on your
wrist, ensuring that it makes good contact with the skin. Peel the protective liner
from the copper foil at the other end of the wrist strap and connect the foil to any
accessible electrical ground that is nearby and exposed.
■ Leave the SafeGuard Controller and SFP modules in antistatic packaging until
you are ready to install them.
■ Always place the SafeGuard Controller on an antistatic mat when it has been
removed from the rack.
Agency Safety Approvals
The SafeGuard Controller has been tested and has obtained the following agency
approvals:
■ CAN/CSA-22.2 No. 60950-1
■
EN 60950-1
■ IEC 60950-1
■
UL 60950-1
Regulatory Compliance and Notices
The SafeGuard Controller meets the following EMC regulatory compliance requirements:
■
EN 55022 (Emissions), Class A
■ EN 55024 (Immunity)
■
Industry Canada Class A
■ FCC Part 15 Class A
■
VCCI Class A (Japan)