Alcatel-Lucent Data Multiplexer Explore 1665, Руководство по установке

Страница: 276 / 408

............................................................................................................................................................................................................................................................
Ring setup and testing: integration procedures
6 - 2
365-372-304R7.1
Issue 1, November 2007
Tools, test equipment and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity Description Comments
Screwdriver(s) A screwdriver(s) with the appropriate head(s) is
(are) required for securing the mounting screws,
repositioning the mounting brackets, installing
the interfacing cables, and for setting the circuit
breakers to the OFF position.
1 ESD Wrist Strap A wrist strap must be worn when handling
circuit packs. Use the electrostatic discharge
(ESD) jack provided on the shelf.
1 Multimeter (Optional) The voltmeter must be capable of measuring
DC voltage in the 40- to 60-volt range. The use
of the voltmeter is optional since the shelf will
alarm or shut down if the proper voltage is not
supplied.
1 DS1 Error Rate Test Set A DS1 error rate test set is required for testing
of DS1 cabling. A T-BERD 2209 or equivalent
is recommended.
1 DS3 Error Rate Test Set A DS3 error rate test set is required for testing
of DS3 cabling. A T-BERD 2209 or equivalent
is recommended.
1 OC-48 Test Set An OC-48 test set is required for testing of
optical circuit packs. An Agilent OmniBER 718
or equivalent is recommended.
1 Personal Computer (PC) See Chapter 3, “Software download and circuit
pack installation” , PC minimum requirements
(p. 3-2) .
1 CIT Interface Cable 8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869).
1 Optical Power Meter