Registering the telephone
8AL90396ENAAed01
60 /90
7.5 Deregister
•
Access MENU.
•
Install
•
Enter the PIN Code (default code: 0000).
•
Apply (
Ok
).
•
Deregister
•
Select the network.
•
Delete registrat.?
•
Yes
(
No
: to cancel).
•
Apply (
Ok
).
7.6 Power mode
You are advised not to select the 50 mW power mode unless required. The '50mW power mode' is
intended for hazardous sites such as nuclear plants where it is requested that emissions do not exceed the
maximum value. The change of mode is made according to the connected system. When connected to a
system, the handset will use the defined mode on this system. If the handset is out of the coverage range,
make sure that the desired system is selected before making the change. If the handset was configured to
connect to any available system, you can restore this configuration after changing the power mode (
Auto.
select
).
•
Access MENU.
•
Install
•
Enter the PIN Code (default code: 0000).
•
Apply.
•
Power mode:
•
Select the power mode using the corresponding softkeys:
Normal
/
50 mW power
.
7.7 Change PIN code
•
Access MENU.
•
Install
•
Enter the PIN Code (default code: 0000).
•
Apply.
•
Change PIN
•
Enter the current PIN code.
•
Enter the new PIN code.
•
Confirm the new PIN code.
ghi
kl
p r s
t uv
ghi
kl
p r s
t uv
ghi
kl
p r s
t uv
ghi
kl
p r s
t uv
