Alaxala AX3630S, Руководство пользователя программного обеспечения

Страница: 867 / 875

40. Error Messages Displayed When Editing the Configuration
839
40.1.24 Uplink redundancy information
Table 40-24: Uplink redundancy error messages
Network prefix of VRRP virtual router ipv6
address and IPv6 address is different on
accept mode.
The network prefixes of the VRRP virtual and real IPv6 addresses are
different.
When specifying accept mode or if accept mode has already been specified,
the network prefixes of the virtual and real IPv6 addresses must match.
Not found channel-group <channel group
number> .
The specified channel group has not been set.
<channel group number> : Indicates the channel group number.
Only one track can assign for virtual router
with priority mode. Only one priority switching track can be assigned to a virtual router.
Only priority mode or decrement mode can
specify as priority operation method at one
virtual router.
You cannot specify both priority switching and priority decrement modes
for a virtual router.
Recovery detection times is greater than
check trial times.
The
recovery detection times
value is greater than the
check trial
times
value.
Set a value that is no more than the
check trial times
value.
The number of critical interfaces for virtual
router is beyond limitation. The number of
Critical Interface
settings per virtual router is above
the maximum.
Message Description
Cannot configure this command to
channel-group port.
This command cannot be set for an interface participating in a port channel.
channel-group <channel group number> is
invalid.
The specified channel group has already been specified for an uplink port.
The same port is specified as a primary port and a secondary port.
<channel group number> : Indicates the channel group number.
Port <nif no.> / <port no.> is invalid. The specified port has already been specified for an uplink port.
The same port is specified as a primary port and a secondary port.
<nif no.>
/
<port no.> : NIF number or port number
Relations between flush-request transmit
and mac-address-table update transmit are
inconsistent.
The sending of flush control frames and sending of MAC address update
frames cannot be set concurrently.
Relations between uplink redundant and
gsrp are inconsistent.
The uplink redundancy configuration is inconsistent with the GSRP
configuration.
Uplink redundancy and GSRP cannot be configured concurrently.
Relations between uplink redundant and
ring protocol are inconsistent. The uplink redundancy configuration is inconsistent with the Ring Protocol
configuration.
Uplink redundancy and the Ring Protocol cannot be configured concurrently
on the same post or channel group.
Relations between uplink redundant and
spanning-tree are inconsistent.
The uplink redundancy configuration is inconsistent with the Spanning Tree
configuration.
Uplink redundancy and the Spanning Tree Protocol cannot be configured
concurrently.
Message Description