Alaxala AX3630S, Руководство пользователя программного обеспечения

Страница: 45 / 875

3. Editing and Working with Configurations
17
quit (exit)
Reverts to an earlier mode. If you are in global configuration mode, this command ends
configuration command mode and returns you to administrator mode. If you are editing data in a
level-2 or level-3 detailed configuration command mode, you are returned one level higher.
For details about operations in user mode and administrator mode, see the manual
Operation
Command Reference .
Syntax
quit or exit
Input mode
Configuration command mode, user mode, and administrator mode
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
None
Response messages
The following table describes the response messages for the
quit (exit)
command.
Table 3-2: Response messages for the quit (exit) command
Notes
Note the following if you use the
quit (exit)
command in configuration command mode:
1. You can use the
quit (exit)
command to temporarily exit the configuration command mode
without saving configuration file changes to internal flash memory. If you do so, the editing
process of the configuration file will still be incomplete, so save the file after you finish
making changes.
2. After editing the running configuration in RAM, if you execute the
quit (exit)
command
without saving the changes to internal flash memory, the startup configuration file in internal
flash memory and the running configuration in RAM will not be the same. For this reason, if
you enter configuration command mode again and then enter the
quit (exit)
command, the
same confirmation message will be displayed even if you have not made any new changes to
the configuration file.
3. Do not press Ctrl + C to interrupt processing while the
end
command is being executed. If the
processing is interrupted, configuration command mode might not end, and subsequent
execution of a configuration command might cause the error message
Logical
Message Description
Unsaved changes found! Do you exit "configure" without
save ? (y/n): You are trying to finish editing a configuration without
saving changes. Enter y to finish editing. If you do so, the
configuration changes that you made will be lost. Enter n to
cancel the
quit (exit)
command. If necessary, use the
save
command to save the edited configuration.