16. Make sure the Battery Connec-
tor Wire is routed through the
correct hole to meet up with the
center oval hole drilled in step 10.
INSIDE BATTERY KIT
INSTALLATION INSTRUCTIONS
WI1516 2/06
345 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs 1-800-ALA-LOCK
For Technical Service 1-800-645-9440
© ALARM LOCK 2006
Publicly traded on NASDAQ Symbol: NSSC www.alarmlock.com
7. Secure the Bat-
tery Mounting
Bracket using the
top door mount-
ing screw that is
located away
from the edge of
the door.
6. Remove lock from door.
8. Using a center-
punch, mark two
holes for drilling:
•
Mark the bottom
Bracket hole for
securing the
Mounting Bracket
(shown)
--and--
•
Mark in the center
oval for routing the
remote battery
wires.
9. Use a #21 drill for
both the bottom
Bracket hole
(shown), and the
center oval.
11. Tap #10-32 threads into the bot-
tom Bracket hole drilled in step 9.
Now the lock's Rear Cover Plate
must be removed, as shown in step
12:
12. Remove the flat-head mounting
screws located at both ends of the
lock.
13. With the Rear Cover Plate
separated from the lock body,
find and disconnect the Battery
Pack Connector.
14. Battery Pack Connector wire is
glued in two locations (shown).
Carefully lift and remove wire from
glue to detach.
15. Replace the Rear Cover Plate.
Route the Battery Connector Wire
through the correct hole as shown
in step 16.
3. Unscrew four through-door
mounting screws (in two door
plates) that secure the lock to the
door.
2. Remove the decorative door
plate covers by sliding them up
from the door plates.
4. Remove Latch
Face Plate.
5. Deadbolt models only: Loosen
the interface cylinder set screw
(skip this step for springlatch
models).
Decorative door
plate covers
Door Plate
Some installations require the batteries powering the door lock be placed inside the protected premises. The following in-
structions describe how to install the Inside Battery Kit for your narrow stile door lock.
Set Screw
Bottom
Bracket Hole
1. Loosen the battery cover screw
and slide the battery cover off the
lock.
Battery Cover
Screw
Glue
Glue
Align the
Engager pin
and the
Driver hole
Mark
here
Battery
Connector
Wire
Battery Pack Connector
10. Enlarge the
center
oval
hole to 7/16".
This center oval hole
is the
only
hole that
must be drilled
all the
way through the
door
.
Note:
Remove the
Battery Mounting
Bracket before
enlarging this hole.
Enlarge to 7/16"
Center Oval
continued