en
50
695264_a
Check if there is any interference (other transmitters, high-power
cables, Wi-Fi, etc.) that may be interrupting good communication
between the remote control and the control unit. If interference is
present, the manoeuvring tool will not function and the green LED
on the remote control will flash.
Generally speaking, all error messages are reset automatically
after one minute. If this is not the case, switch the electronics on
the manoeuvring tool and remote control off using the main switch
for at least 15 seconds.
Unit is not functioning or is running intermit-
tently:
Check the battery in the remote control. If it is flat, replace the 9V
battery.
The caravan battery could be flat. If it is, recharge it fully first.
The caravan battery could be almost flat when the drive rollers are
engaged. Check the current drop on the caravan battery display.
If this falls to well below 10 Volt immediately, charge or replace
the caravan battery.
The caravan battery could be overloaded. Check your charger. Try
to discharge the battery a little with an additional consumer (light
or another 12V load). If this does not resolve the problem, replace
the battery before taking any other measures.
Check the cable connection between the caravan battery and the
control unit.
Poor connections or corroded battery connections can cause inter-
ruptions. Check the connections, clean them and reconnect them.
Ensure that the distance between the remote control and the car-
avan is no more than 5 metres. If there is no signal between the
remote control and the control unit, the manoeuvring tool will not
function and the green LED on the remote control will flash.
Check if there is any interference (other transmitter-
s,high-power cables, etc.) that may be interrupting good
communication between the remote control and the control unit. If
interference is present, the manoeuvring tool will not function and
the green LED on the remote control will flash.
Generally speaking, all error messages are reset automatically
after one minute. If this is not the case, switch the electronics on
the manoeuvring tool and remote control off using the main switch
for at least 15 seconds.
The drive rollers are not gripping:
The motor or gears are faulty, contact your AL-KO supplier.
The drive rollers are turning on the wheels:
Check the distance between the rollers and tyres. Position the
rollers closer to the tyres.
ADVICE
In the case of faults that are not listed in this table, or faults that you cannot rectify without assis-
tance, please contact our customer service department.
Содержание Ranger MS 1
