AL-KO EasyMow 700, Руководство пользователя

Страница: 38 / 80

en
Troubleshooting
38 Robotic lawn mower
TROUBLESHOOTING
General
Error message Possible cause Solution
Boundary cable defective,
robotic lawn mower does not find base
station.
Check boundary cable for interrupti-
ons, if necessary have it tested by a
service partner.
Battery exhausted. Battery service life exceeded. Have
battery renewed by a service partner.
Charging electronics faulty. Have charging electronics renewed by
a service partner.
Low battery vol-
tage
Robotic lawn mower does not touch
charging contacts.
Put robotic lawn mower into base
station and check if charging con-
tacts make contact.
Have charging contacts checked
and renewed by a service partner.
Incorrect PIN
code
PIN code has been entered incorrectly. Enter correct PIN code. Three at-
tempts are allowed, after which a PUK
code must be entered.
Working time of robotic lawn mower is
too short.
Programme longer working times.
Mowing area too big. Reduce mowing area.
Ratio of cut height to tall grass is incor-
rect.
Set cutting height taller, then reduce in
stages to required height.
Cutting blades are blunt. Renew cutting blades or have them
sharpened by a service partner; install
with new screws.
Mowing result is
uneven
Grass is blocking rotation of cutting
blade plate or motor shaft or is making
it more difficult to rotate.
Remove grass and ensure that cutting
blade plate can rotate freely.
Robotic lawn mo-
wer is mowing at
wrong time
Time on robotic lawn mower or start
and finish time for mowing must be set.
Set time.
Robotic lawn mo-
wer is vibrating
Imbalance on cutting blade or cutting
blade drive.
Check and clean cutting blade and cut-
ting blade plate, renew if necessary.
Fault code
Error message Possible cause Solution
CN001: Tilt sen-
sor
Max. tilt exceeded
robotic lawn mower has
been carried
Slope too steep
Place robotic lawn mower on a flat surface and
acknowledge fault.