AL-KO EASYAIR RO-01, Инструкция по установке и эксплуатации

Страница: 13 / 76

Subject to changes in line with technical progress.
13
Safety instructions
3313737
„
All electrical parts are protected with fixed, securely fastened covers consisting of insulating material (switch cabinet
hood) which can only be removed using tools.
„
Avoid sparking in the vicinity of the EASYAIR
®
unit.
„
Wear personal protective equipment (e.g. ear protection) during operation of the EASYAIR
®
unit.
2.3.2 Safety instructions for maintenance
„
Damaged parts are only permitted to be replaced with original spare parts.
„
For repair and maintenance work, disconnect the EASYAIR
®
from the mains supply at all poles.
„
General maintenance instructions in the installation and operating manual of the AL-KO THERM must be observed
under all circumstances.
„
Observe the delay time of the fans. Observe a waiting time of at least 3 minutes, until the fan impellers are stationary,
before opening the inspection doors.
2.3.3 Personal safety instructions
„
The EASYAIR
®
may only be operated by persons who are trained in operating it and expressly authorised to use it.
„
Personal protective equipment is required for work on the EASYAIR ® !
„
To avoid hazards during operation, all of the operator's company, operating and working instructions apply in addi-
tion to this installation and operating manual.
„
The installation and operating manual must be kept at a suitable, known place in the workplace.
„
The operator of the EASYAIR
®
unit must draw up operating procedures in an understandable form and in the lan-
guage of the employees, taking the Installation and Operating Manual and the operating conditions into considera-
tion.
2.4 Residual dangers
The installation may present a danger if it is not operated by trained personnel and/or is used improperly or not according
to its designated use.
Residual hazards are potential dangers that are not immediately obvious, e.g.:
„
Injuries due to failure to observe the safety instructions, standards, directives or regulations.
„
Injuries caused by uncoordinated work.
„
Danger caused by working on the electrical installation, cables and connections.
„
Transporting, unpacking and setting up the unit; these may result in crushing, cutting, puncture or impact injuries.
„
Tipping of the unit; uneven and loose surfaces promote unit tipping.
„
There is a risk of stumbling, slipping, falling and falling down when setting up the unit and the accessory parts.
„
There is a danger of electric shock due to damaged and defective electrical components.
„
Electrical connection cable: Danger due to stumbling, falling and slipping.
„
Noise (hearing damage).
„
Human misconduct: Non-compliance of the safety instruct ions, standards and regulations.
2.5 Training
The owner of the AL-KO EASYAIR
®
must regularly train their personnel in the following subjects:
„
Compliance with and use of the Installation and Operating Manual as well as statutory regulations.
„
Intended operation of the AL-KO EASYAIR
®
unit.
„
Observance of all company, operating and working instructions at the operator's installation site.
„
What to do in an emergency.
„
VDI 6022