Subject to changes in line with technical progress.
25
3420878
Delivery, transport, storage
Use a pallet truck to lift the one-way pallets with the components of the compact air handling unit off the transport vehicle
and transport them to their intended location.
Only ever transport one loaded one-way pallet using the pallet truck.
Position the forks of the forklift in the middle of the one-way pallet. Pay attention to uniform weight distribution.
Lift the one-way pallet from the loading area of the transport vehicle and place it on level ground at the destination.
NOTE
To protect the surface of the unit during transport, we recommend that the outer packaging
(plastic film) is left on the unit and removed only at the final installation site.
4.3
Storage prior to installation
If the compact air handling unit has been delivered, but cannot be installed immediately in its intended installation site,
observe the following points:
Store the compact air handling unit in its original packaging or protect the unit from dust using a flexible cover dur
-
ing prolonged storage.
Store the compact air handling unit in a dry and weatherproof location.
Do not store the compact air handling unit outdoors.
Frequent and, above all, abrupt temperature changes must be avoided during storage. This entails a risk of moisture
condensing. Mould could develop as a result.
In order to avoid bearing damage, the fans must be turned once a month during standstill times of more than one
month. To do this, open the left maintenance door and turn the two fans by hand. The compact air handling unit
must not be connected to the power supply during this time.
In the case of storage periods of more than one year, the ease of movement of the fan bearings must be checked (by
turning by hand) before installation. This work must only be carried out with the compact air handling unit switched
off, disconnected from the power supply and protected against restart. Please contact your Customer Service.
Pay attention to unusual noises when switching on the unit after prolonged storage. If in doubt, switch off the unit
immediately at the unit main switch. Disconnect the unit plug.
Avoid distortion of the housing or other damage during storage.
Damage resulting from improper packaging and storage is at the expense of the person responsible.
4.4
Disposal of packaging
When disposing of the packaging, proceed according to the relevant local environmental and recycling
regulations in your country and community applicable at the time.
