AL-KO 113691, Перевод оригинальной инструкции по эксплуатации, Страница: 35 / 424

469545_e 35
Operation
1. Pour the petrol and 2-stroke oil into a fuel
mixing bottle (quantities, see table, depend-
ing on the size of the fuel mixing bottle).
2. Close the fuel mixing bottle and shake vigor-
ously several times so that the petrol and oil
can mix thoroughly.
Pouring in the petrol/oil mixture (15)
1. Place the appliance on a level, horizontal sur-
face. The cap of the fuel tank must be facing
upwards.
2. Wipe the fuel tank cap (15/1), the fuel tank
(15/2) and the surrounding appliance parts
clean so that no dirt can get into the fuel tank
when the petrol/oil mixture is poured in.
3. Open the fuel tank cap slowly so the pres-
surised petrol/air mixture can slowly escape
from the fuel tank into the atmosphere. Leave
the cap hanging on the fuel tank.
4. Insert a funnel (15/3) into the filler neck (15/4)
of the fuel tank.
5. Pour the prepared petrol/oil mixture from the
fuel mixing bottle (15/5) into the fuel tank up
to the lower edge of the filler neck, but not
higher.
6. Remove the funnel and screw on the cap fin-
ger-tight.
7. Wipe any spilled petrol/oil mixture off the ap-
pliance and the surface.
6 OPERATION
6.1 Preparation
Before starting
■
Place the trimmer level and free of obstacles
on the ground. The cutting tool must not be
touching any objects or the ground.
When starting
■
Do not stand on the shaft to avoid damage to
the shaft and/or the drive shaft inside the
shaft.
■
Make sure you are standing securely and
hold the trimmer firmly at the housing flange.
Positions of the choke lever
CHOKE RUN
Cold start
If the engine is cold, i.e. if it has not been in use
for more than 5 minutes, a “cold start” is carried
out.
Warm start
If the engine is still warm from use, i.e. shortly af-
ter it was switched off, a "warm start” is carried
out. The choke is not used here.
6.2 Starting/stopping the engine, BC 223 B
(07)
Cold start
1. Move the on/off switch (07/1) to the START
position.
2. Setting the throttle lever:
■
Press and hold throttle lever (07/2).
■
Press and hold the locking button (07/3).
■
Release the throttle lever (07/2) – it en-
gages at half throttle.
■
Release locking button (07/3).
3. Move the choke lever (07/4) to CHOKE.
4. Briefly and firmly press the primer (07/5) ap-
prox. 10 times.
5. Starting the engine:
■
Press the appliance firmly onto the
ground with one hand.
■
With the other hand, pull the starter han-
dle (07/6), first carefully and slowly until
resistance is felt, and then firmly and
quickly upwards until resistance is felt
again (approx. 1 arm length).
■
Allow the starter rope to coil up again, but
without releasing the starter handle.
■
Repeat the previous step several times
until the engine starts, but stalls again.
6. Moving the choke lever to RUN:
■
Press the appliance firmly onto the
ground with one hand.
■
With the other hand, pull the starter han-
dle (07/6), first carefully and slowly until
resistance is felt, and then firmly and
quickly upwards until resistance is felt
again (approx. 1 arm length).
■
Allow the starter rope to coil up again, but
without releasing the starter handle.
■
Repeat the previous step several times
until the engine starts and runs smoothly.
7. Allow the engine to warm up for a few min-
utes.