TRM138 Configurator
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany Tel.: +49 (0) 511 16 59 672-0 · www.akytec.de
28
28
9
TRM138 Configurator
►
NOTICE
Before starting
Before switching on, make sure that the device was stored at the specified ambi-
ent temperature (+1... +50 °C) for at least 30 minutes.
The complete list of parameters is shown in Table B.1.
The software and the manual are included on the USB stick and available for download
from
The device must be configured in order to use it in RS485 network. Proceed as follows:
– install the configuration software TRM138 Configurator on the PC
– connect the device to the USB interface of the PC over USB/RS485 adapter (not
included)
– connect the power supply to the terminals L / N
– turn on the device
– start the TRM138 Configurator
If the factory settings of the device have not been changed, the connection to the device
is automatically established, the device automatically recognized, its configuration pa-
rameters read out and an appropriate configuration mask open.
If it does not happen, parameters of the configurator should be changed (see Table 9.1).
Table 9.1 Network factory settings
Parameter
Name
Default
Baud rate, bit/s
bps
9600
Data bits
len
8
Parity
prty
none
Stop bits
sbit
1
Address bits
a.len
8
Address
addr
16