Configuration
akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany Tel.: +49 (0) 511 16 59 672-0 · www.akytec.de
24
24
8
Configuration
Configuration can be performed using function keys or with PC using the configuration
tool “TRM138 Configurator”.
The configuration can be made individually or using standard configurations. Standard
configuration schemes can be select using the parameter group PL-3. They can be also
changed and saved.
System menu provides access to all parameters of operation modes, inputs, control
channels, RS485 communication and access protection. The parameters are described in
the Table B.1. The parameters are divided into five groups PL-0
…PL-4 (see Fig. 8.1).
Fig. 8.1 Groups of parameters
To enter the system menu from the control mode press for at least 3 sec. the key
until “
” appears on the display Z1 and “
” on the display Z2.
Select the parameter using
keys and then press
.to change the parameter.
Press the
key to return to the upper level menu (or to the control mode).
Access protection can be set for each parameter group and is only via system menu
available. Setting instruction for the access protection for the parameter group PL-0 is
shown in Fig.8.2. The passcode is “-10” and cannot be changed.
Fig 8.2 Access protection