Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
1.4. Now set the desired temperature switch-off point (0 ~ 40° C) with the stepless thermostat control dial (right-
hand knob). It is best to do this as follows: Turn the thermostat knob to the highest temperature (MAX.) and let
the heater run until your desired temperature value is reached. Now turn (adjust) the control downwards
towards the minimum until the heating function switches off automatically. Now leave the control dial
(thermostat) in this position and whenever it gets colder in the room, the heating rod automatically starts to heat
and when the adjusted temperature is reached again, the heating rod automatically switches off again!
Note: The fan of the heater is not controlled by the thermostat. If the selected target temperature is reached, the
heating element switches off automatically, but the fan continues to run !
2. Switch off
To switch off the unit, turn the stepless thermostat control knob (right-hand knob) to minimum (MIN) and let the unit
run in fan mode for about 5 minutes to allow it to cool down. Afterwards, also turn the operating strength adjustment
knob to "0" to switch off the unit completely.
3. Manually resetting the high-voltage heater
In case of malfunction of the heater, e.g. no heat output, overheating or other problems, the following procedure is
recommended:
3.1 Unplug the heater from the mains and let it cool down.
3.2 Check that the operating strength adjustment knob is in the OFF position and the
thermostat control dial is turned to MIN.
3.3 Take a pointed pen/object and press the reset button until you hear a short click (see
fig.). This resets or zeroes the electrical system of the heater.
3.4 Now you can reconnect the heater to the mains plug and the heater should work
properly again.
4. Cleaning & Storage
Always unplug the heater from the mains and allow it to cool down completely before cleaning it !
4.1 Cleaning the housing:
-
Use a soft and damp cloth to clean the outside of the housing.
-
Use only mild cleaning agents to clean your heater and no aggressive cleaning agents, these can damage your
appliance !
-
Please make sure that no water gets inside your heater at any time !
4.2 Storage:
-
We recommend that you repack the unit in its original box for storage.
-
Store the heater in a dry and sufficiently ventilated place/space.