Akiyama MC-Club, Инструкция по эксплуатации, Страница: 5 / 12

3
16.-Booth level control: Controls independently from Master headphones.
22.-
an external amplifier. Please note that the level of this output will
not in any case be displayed on the bargraph
level meter;
consequently, please check carefully for your amplifier not
right
being overloaded.
23.-Headphones level control: With a stereo headphone
17.-Mono/Stereo Selector: We can transform output signal,
connected, you may control the headphones volume. Please
normally stereo, in mono.
18.-Auxiliary 1 input: this is a front panel line level input check your headphones impedance for a minimum of 32 Ohms
selectable at channel 1 by means of the Input assign switch of and be aware of high-impedance headphones reducing the
channel 1. maximum output power of this output, so that you should choose
19.-Auxiliary 2 input: this is a front panel line level input
a headphone with less than 200 Ohms of impedance.
selectable at channel 2 by means of the Input assign switch of
channel 2.
20.-Stereo/Split selector for headphones Position "Stereo"
will make you hear the preselected signal by means of CUE
controls in stereo, while position "split" will make you hear the
CUE preselected signal on one earcup and the Master output
signal on the other earcup.
21.-Headphones connector: Jack 6.3 stereo. Connect here the
Cue Pan: By means of this function, you can preview your
forthcoming mix by crossfading between the preselected
headphones signal on the left side of the control and the Master
output signal (pre pot) on the
side of the control.
:
FUNCTIONS
e
ng
li
sh
OPERATING THE MIXER
MICROPHONE INSERTS
Each of the 3 avaialble microphones is fitted with an insert
connection. This allows us to place in serial with the Mic an
external FX device. If no external module is plugged to
Insert the microphone will work as usual. If we plug into
Insert an effects module we will have the following:
mc club
input/ output
MICROPHONE FX UNIT
Mic input
Mic insert
to mic channel
processed
signal
original
signal
input output
SETTING INPUT LEVELS Moreover, we have to realize that the LED bar gives us the signal
level
after it is processed by the equalizer. If we boost up the
To set input level turn GAIN pot until the LED bar of respective
equalizer we can reach saturation despite we adjusted the system
channel depicts steady around 0dB. Over this value we are
for maximum eficiency with flat equalizer response.
close to saturation (although is acceptable to have peaks at the
Note: the Gain adjustment may have to be reset according to
red level zone). This task will have to be done for each of the
equalizer setting, pay attention to the LED bars when boosting
channels because different inputs sources may have different
the equalizer.
levels.
MIXER SETUP
MC Club mixer has been designed in order to be able to mount is
at a rack device or at table top. The chassis of the mixer is tilted
22 degrees to allow an easy handling of frontal commands.
Rack Assembly Tabletop Assembly
22 degree