KUMO SDI Routers and Control Panels v4.7r1 26 www.aja.com
Access Settings
Access settings permit you to hide or lock individual Destinations. On KUMO
6464-12G routers that individual Destination's cable length can also be specified.
Figure 18. Button Access Settings
Hide
You can hide selected Destinations from display on the HOME Screen by
activating the Hide box. This setting applies only to the local browser.
Lock
If you want to lock any of the Destinations from Source changes, activate the Lock
box for the desired Destination.
NOTE: This lock is a universal lock for all KUMO devices controlling the selected
Destination. It is tallied throughout the network and can be released from other
KUMO control devices on the network.
Long Cable (KUMO 6464-12G model only)
The KUMO 6464-12G router includes an additional SDI output setting to increase
interoperability with downstream equipment when short output cables are used.
The setting is available for each individual output. The default setting is L (for
long cable) and can be set to S (for short cable), which may improve performance
when the output cable is 10m or less of Belden 1694A or equivalent.
NOTE: Changing the router configuration operating mode (Normal, Dual, or Quad)
resets the KUMO 6464-12G Long Cable settings. These settings will need to be
manually re-configured to match the actual cable lengths used by each output
port in the new operating mode.
Reset to Factory Defaults
The "Reset to Factory Defaults" button can be used to return all router user
settings to factory defaults.
Salvos Configuration
The Salvos screen lets you configure up to eight salvos for the selected
KUMO router. Each salvo can route any number of Sources to any number of
Destinations, including the same Source to multiple Destinations. Crosspoints not
included in a salvo remain unchanged.
When you first select the Salvo screen the eight Salvo buttons are shown. Buttons
with currently configured salvos are colored green.