KONA IP Transport, Capture, Display v16.0r1 42 www.aja.com
Destination IP Addr 2
This field will only be available when ST 2022-7 is Enabled in the IP Network
section. This filter lets you specify the network address where a duplicate
multicast from another ST 2022-7 device on the network can be found. That
device should be sending two duplicate IP video multicasts and the IP addresses
of those streams will be specified in ‘Destination IP Addr’ and ‘Destination IP Addr
2’.
Destination Port 2
This filter lets you specify the port number being used to send a multicast to the
‘Destination IP Addr 2’ address specified above.
Match Checkboxes
The ‘Match’ checkbox can be used to match the Destination Port to the
Destination IP Address.
Playout Delay
The Playout Delay slider can be used to adjust the amount of buffering before
packets are sent to the network, in a range of 0 to 150 milliseconds. Network
traffic conditions may require setting a larger buffer. Default is 50 milliseconds.
Path Difference (ST 2022-7 only)
The Path Difference slider can be used to adjust the buffering used for redundant
operation, where the paths through the network of the two streams may
have different delays. Adjustable in a range of 0 to 150 milliseconds, with 50
milliseconds the default. See
"IP Network Screen, ST 2022-7 Operation" on page
IP Output Screen
The IP Output Screen on KONA IP lets you define parameters for sending outputs
from the KONA IP card onto the network.
