KONA Capture, Display, Convert v15.2 47 www.aja.com
NOTE: This setting only applies to dual channel monitoring environments.
Monitor Level
Allows adjustment of the analog monitor level, to match the audio to your
operating levels. Select from:
• +24 dBu FSD
• +18 dBu FSD (default)
• +15 dBu FSD
• +12 dBu FSD
Audio Configure
Delay In/Out
Here you can set up to 6 frames (in tenths of a frame) of delay for KONA audio
input and output. The AJA Control Panel delays all audio outputs—SDI, HDMI,
and Analog.
IMPORTANT: If you use this Control Panel delay, do not use other delay settings in your
applications. They can conflict.
Audio Mixer Screens
NOTE: The Audio Mixer screens are not available in KONA 4 in UFC Mode or KONA 5 in 8K
Mode.
The Audio Mixer screen has two tabs; Capture Monitor and Playback Monitor.
These tabs display what sources are available for monitoring / mixing via the AJA
hardware when in either of those two modes (if applicable). The controls on this
screen are dedicated only to monitoring adjustments, and do not affect the level
at which inbound audio signals are captured to storage.
The selection check boxes and screen slider controls affect the following KONA
outputs:
• SDI Embedded Audio Out
• HDMI Embedded Audio Out.
IMPORTANT: Even though you can hear changes in the signals and levels adjusted
with the Audio Mixer screen, these changes are NOT recorded to disk during
NLE Capture or Audio Punch In / Voice Over to Timeline. In addition, muting or
activating sources on this screen will not affect audio signals being recorded. The
Audio Mixer screen is dedicated for monitoring only, not program mixing.
The branching arrow on the lower right indicates which sources are being routed
for monitoring in that operating mode, and is colored blue when active and red
when disabled.
