KONA Capture, Display, Convert v15.2 41 www.aja.com
to 60 fps or 1080i/1080p up to 30 fps) in a single serial digital interface at the
nominal 3 Gbit/s.
• 3Ga - Single link HD output using one BNC. The Level A format is the direct
mapping of uncompressed 1080p (up to 60 fps) video into a serial digital
interface at the nominal 3 Gbit/s.
• 2xHD-DL: Dual link HD output using two BNCs. The Level B-DL format is the
mapping of dual-link HD-SDI/SMPTE 372M (i.e.: 1080p up to 60 fps) in a single
serial digital interface at the nominal 3 Gbit/s.
"SDI Output Screen in 4K Mode" on page 64
for information about 4K
Transports.
SDI Output Screen, KONA 4 in UFC Mode
On KONA 4 in UFC Mode, two SDI output are available, (SDI 1 and SDI 2) which can
be configured differently from each other. For example, one output can be the
Primary format and the other output cab be the Secondary format.
Figure 29. SDI Output Screen, KONA 4 in UFC Mode
SDI 1
Sets the output format for SDI 1. Parameters are the same as
above, except you can select a Secondary Format and 4K Transport
settings are not available:
Select
Same as above with the addition of a Secondary output format:
• Secondary - When selected, this indicates that the SDI output is set to a format
different from the framebuffer (Primary Format). That secondary format value
will be listed in green. This shows that active processing of the video is taking
place (format change and possibly up- or down-conversion).
