AJA Ki PRO ULTRA, Руководство по установке и эксплуатации

Страница: 58 / 98

Ki Pro Ultra v1.2r1 www.aja.com 58
55.71 Daylight Savings
This parameter manually sets the internal Ki Pro Ultra clock for either Daylight Savings or
Standard Time. The options are:
• Daylight Savings ON
• Daylight Savings OFF
70.10 Screen Saver
Timeout
This parameter sets the number of minutes before Screen Saver dims the Ki Pro Ultra LCD
display.
70.2 DISPLAY
INTENSITY
This parameter determines the brightness of the alphanumeric LCD display and front
panel back-lit buttons. A dimmer display uses less power.
80.1SERIAL NUMBER
This parameter displays this Ki Pro Ultra’s unique serial number (Read-only).
80.2 SW VERSION
This parameter displays Ki Pro Ultra’s software version level (Read-only).
91.1 RECALL PRESET
This parameter recalls the Ki Pro Ultra to a previously saved preset configuration stored
using parameter 92.1. Push the User Control Knob to enter the Preset Recall scale and
scroll to choose the Preset (1 to 20). Press the knob to select and confirm action by
scrolling and clicking on OK or Cancel.
92.1 STORE PRESET
This parameter saves a preset configuration to the selected storage register. Use the User
Control Knob to scroll to the number of the Preset register. To store, press the knob, and
then select and press OK. The message
[COMPLETE] is displayed after a successful store.
99.1 FACTORY RESET
Selecting this parameter and then pressing the User Control Knob brings up the Confirm
Action screen. Press on OK to recall Ki Pro Ultra’s factory default settings.
Recalling factory defaults does not affect these settings: Encode Mode, Encode Type, IP
Config, IP Address, Subnet Mask, Default Gateway, System Name, or Date and Time.
BOSTON HELSINKI HANOI SEATTLE
CARACAS CAIRO SINGAPORE
BUENOS AIRES TEL AVIV JAKARTA
RIO DE JANEIRO BEIRUT HONG KONG
Table 1. Ki Pro Ultra Time Zone Options
variable from 1 to 60
minutes
Push the User Control Knob to enter the time scale and scroll
to choose the setting. Press the knob to exit.
variable Push the User Control Knob to enter the intensity scale. You
can scroll to dim or brighten the alphanumeric display and
activity indicator LEDs in steps from 1 (dim) to 8 (brightest)
Default: 6
Push the knob to exit.
Caution!
Selecting this parameter and recalling factory defaults will overwrite the current
settings (with the exception of network settings, which are retained).