![AJA IPR-10G2-HDMI Скачать руководство пользователя страница 19](http://html.mh-extra.com/html/aja/ipr-10g2-hdmi/ipr-10g2-hdmi_installation-and-operation-manual_2883369019.webp)
10 GigE IP Mini-Converters SMPTE 2110 IP Transmit/Receive v2.2r1 19 www.aja.com
10 GigE IP Mini-Converters require a network connection for initial configuration,
control and firmware updates. 10 GigE IP Mini-Converters are shipped from the
factory with DHCP enabled, and support automatic network discovery via SSDP
and MDNS.
To Set Up the Unit with a Web Browser
1. Connect the 10 GigE IP Mini-Converter Control Port to the intended
network with an Ethernet cable.
2. The intended network’s DHCP Server will assign an IP address and the 10
GigE IP Mini-Converter will join that network.
3. Locate and connect to the AJA 10 GigE IP Mini-Converter.
Windows PC Host
A. Open Windows Explorer.
B. Navigate to the Network.
C. Click on the Network to enumerate network devices.
D. Search for either “IPT-10G2,” "IPR-10G2," or the device’s Serial Number.
E. Double-click on the intended 10 GigE IP Mini-Converter. The host machine
web browser will launch and display the web UI for the device.
macOS Host
A. Go to System Preferences > Sharing and turn on File Sharing.
B. Open the Finder Window.
C. Navigate to Shared > All…
D. Click on All… to enumerate network devices.
E. Search for either “IPT-10G2,” "IPR-10G2," or the device’s Serial Number.
F. Double-click on the intended 10 GigE IP Mini-Converter. The host machine
web browser will launch and display the web UI for the device.
NOTE: If the above does not work, then you will need to download and install an MDNS
browser to assist with discovering network devices on a macOS host.
Initial Setup By AJA eMini-Setup
1. Acquire AJA eMini-Setup (version 2.1) from the AJA website for either
macOS or Windows:
https://www.aja.com/family/software#eminisetup
2. Install eMini-Setup:
A. Unzip the Installer.
B. Run the .dmg file on macOS or the .msi file on Windows.
3. Connect Power to your AJA Ethernet equipped Converter.
4. Connect the USB config cable to the computer running eMini-Setup.
5. Open eMini-Setup and configure the device’s network settings.
NOTE: DHCP is enabled by default, and if the device is connected to a DHCP server the IP
address field will populate.
6. Enter the IP address into a browser window. The web UI for your AJA device
will display.
7. Use the web UI to fully configure and control your AJA Device.