FS2 v2.1r1
www.aja.com
54
and influenced by the composite signal on the
Component Y/G
input. For example, in the
VIDEO
menu, setting
Video1 Input
to the value of
Component
, switches the composite
signal on the
Component Y/G
input into the Video 1 Processor.
2 Component Out
Format
This parameter configures the format of the
Component
video output for SMPTE, Beta,
RGB, or Composite. Selecting
Composite (Y)
programs the
Component (Y/G)
output to
deliver a composite signal. In this case, all parameters set to a value of
Component
are
subject to and influenced by the composite signal on the
Y/G Component
output. For
example, in the
OUTPUT
menu,
Component Out
, selecting
Processor2
will switch the
composite signal from Video Processor 2 to the
Component Y/G
connector.
3 Analog Audio Std
This parameter sets the
Analog Audio Input
and
Output
levels of the FS2 with reference to
full scale digital (0 dBFS). Selections range from consumer levels (+12 dBu) to SMPTE
professional (+24 dBu).
NOTE:
See Chapter 3 FS2 Audio Level Choices—Pro or Consumer regarding audio levels.
4 SDI1 3G Detect
This parameter configures 3G operation of the SDI 1 video input.
In
Auto Detect
mode, the hardware looks for SMPTE 352 Payload ID ANC data on the
video inputs to determine whether there are two independent 1080i signals (Dual
Stream) or a single 1080p50/60 signal. If there is no SMPTE 352 data, the default is to
assume
1080p50/60
(single), but you can manually instruct the FS2 to always assume
either
1080p50/60
or
Dual Stream
by selecting one of those choices.
SMPTE YPbPr (default)
Beta YPbPr
Composite (Y)
Configure the Component Video Input source as SMPTE YPbPr.
This is the default for HD component video.
Configure the Component Video Input source as Beta YPbPr
(standard definition).
Configure the Component Video Input source as composite,
providing a second composite input (requires version 1.1
firmware).
SMPTE YPbPr (default)
Beta YPbPr
RGB
Composite (Y)
Configure the Component Video Output as SMPTE YPbPr. This is
the default for HD component video.
Configure the Component Video Output as Beta YPbPr (SD).
Configure the Component Video Output as RGB.
Configure the Component Video Output source as composite,
providing a second composite output (requires version 1.1
firmware).
+24 dBu (default)
+18 dBu
+15 dBu
+12 dBu
Select
+24 dBu
as the expected analog audio level.
Select
+18 dBu
as the expected analog audio level.
Select
+15 dBu
as the expected analog audio level.
Select
+12 dBu
as the expected analog audio level.
(Above settings correspond to maximum amplitude–0 dBFS)
Auto Detect (default)
1080p50/60
Dual Stream
Automatically detects presence of 1080p50/60 or Dual
Stream video.
Configures the SDI1 input for 1080p50/60 (single) video.
Configures SDI 1 for Dual Stream 3G video (uses SDI 1
and SDI 2 in Input Crosspoint matrix).
USO
RESTRITO
