10 GigE IP Mini-Converters SMPTE 2110 IP Transmit/Receive v2.1 11 www.aja.com
Figure 8. IPR-10G-HDMI Connections
2 Channel
Unbalanced
Analog Audio
Output
(RCA Jacks)
Output
HDMI
Connector
USB
Port
+5-20 VDC
Power
Input
Control
LAN
SFP+ Cage
for 10 Gbps
Ethernet
Lock LED
Ready LED
Link/Act
LED
Control LAN, Ready, Link/Act, and Lock LED Behavior
The Control LAN LED illuminates to indicate a link. Blinking indicates activity.
The Ready LED illuminates green when the unit has finished powering up and is
ready to use.
The Link/Act LED 1 and Link/Act LED 2 behavior is as follows:
• Off - No SFP+ module present
• Red - SFP+ module present, no link
• Green - Link is up
• Green flash - Link is up and there is Tx or Rx activity
The Lock LED behavior is as follows:
• Off - No Precision Time Protocol (PTP) is detected
• Red - A PTP error is detected
• Yellow and flashing - Locking Phase 1
• Yellow - Locking Phase 2
• Green and flashing - Locking Phase 3
• Green - Signal is locked
NOTE: Achieving locked status may take 5 or more minutes depending on network jitter
behavior. The output of the unit will still function during the locking period.
Installation Overview
Detailed instructions are provided in
"Chapter 2 – eMini-Setup" on page 14
and
"Chapter 3 – 10 GigE IP Mini-Converters Web Interface" on page 23.
As an overview, however, there are two methods available for initial setup for
10 GigE IP Mini-Converters:
1. Using a web browser on the host computer connected to the same network
as the 10 GigE IP Mini-Converter, or
2. Using the AJA eMini-Setup application running on the host computer that is
directly connected to the 10 GigE IP Mini-Converter via USB.
