HELO Plus H.264 Streaming and Recording Encoder v1.0 11 www.aja.com
Retained Settings With Soft Reset
System name
Scheduler last remote sync
System password
Storage status
User authentication
SSDP enable host
Time source
HTTPS enable
NTP server
IP address type
Time, date (formats are reset,
time/date values are not)
IP address
Time zone
Subnet mask
Daylight savings
Default gateway
NOTE: The Soft Reset function above can also be performed using the HELO Plus's web
browser UI (Presets Screen). See
"Default Preset (Web UI)" on page 45
for more
information.
Hard Reset -
Pressing and holding the recessed hardware button for five seconds
performs a hard reset that returns all settings to their factory defaults and
then reboots the device. Network connection parameters will be reset (DHCP),
and all layouts, graphics, saved presets, and calendars will be deleted. Hard
reset is intended for factory use to ensure a system is in a new state before
shipment, and for use by equipment loan or rental houses that need to put
units into a new state, and also to ensure any saved passwords are erased.
Ports/Slots
USB 3.2 Gen 1 Storage Port
USB port for connecting a flash drive for recording.
SD Card Slot
Cards and Formatting
• SDHC (FAT32)
• SDXC (exFAT)
Front Panel Status LEDs
Record LEDs
These two LEDs report the status of the Primary and Secondary recordings.
Green -
Configured media is mounted and ready
Flashing Green -
Recording in progress
Amber -
Recording is not configured or no network connection for recording
Flashing Amber -
Loss of signal
