AJ Aircraft Raven 73", Руководство по сборке

Страница: 13 / 26

aj-aircraft.com Page 12
Ensure all set screws are tight on the pre-assembled tail
wheel assembly.
Use the landing gear fasteners (4-40) locate on the
bottom of the fuselage along with 2 flat washers located
in the landing gear package to mount the carbon fiber
landing gear. Add a drop to removable thread locker to
screws during assembly.
Fuselage
Carefully locate the mounting holes for the wing and trim
away the covering. There will be 2 holes for wing
alignment pins, 1 hole for the wing bolt, and a slot to pass
the servo wire through. Shine a flashlight through the
fuselage to highlight the holes if you have trouble
locating them.
Carefully locate the horizontal stabilizer pocket. Use a
trim iron to seal the covering around the edges of the
pocket before trimming. Use a new hobby knife blade to
cut though the covering.
Review the servo configurations as described on page 4
before cutting the covering over the servo pockets.
Below the horizontal stabilizer slot there is a servo pocket
on each sides of the fuselage. Cut only one of them open
if you plan to use 1 elevator servo. Cut one open on each
side if you plan on using 2 elevator servos. Use a sealing
iron to attach the covering around the opening before
cutting.
Slide the horizontal stabilizer through the fuselage
pushing it all the way forward. Center it side to side.