Aixro XR50, Руководство по эксплуатации

Страница: 9 / 23

© Aixro GmbH / Woelfle Engineering GmbH 8/23

If the exhaust is attached without strain or tension, the rubber underneath the cradle can be
removed. If not, it should at least be replaced by a strong spring, as the rubber will not with-
stand the heat from the exhaust.

If you should not have an exhaust gasket, you can just bolt the exhaust header directly to the
engine.
4.6. Electrics
From 2011 The Aixro XR50 is equipped with a PVL ignition, which includes some additional
features for onboard starting. Even when equipped with the onboard starter the engine will
start easily with an external starter.
4.6.1. External Starter
To start the engine with an external starter, use a 22mm socket on the clutch nut. The clutch
nut should be easily accessible through the bodywork, so the starter can be removed easily
after starting the engine.
1.
Connect the ignition wires as shown on the diagramme below.
2. Attach the CDI box. Typically the best position is on the back of the seat. The CDI box
should not be too close to the engine or the exhaust.
3. Mount the stop button / kill switch, so it is easily visible for the driver. The steering
wheel is the best location. If it should not be possible to attach the switch to the steer-
ing wheel, you should drill a hole (Ø 15mm) in the Nassau Panel (within easy reach of
the driver) and attach the switch there.
4. Cover the wires you do not need and attach them with cable ties.
5. Drill or cut a sufficiently wide (long) hole in the side pod, and deburr it. Keep in mind
that the engine position varies depending on the gearing and chain length.
! Make sure the wires cannot wear or make contact with the ground and open ends are
protected. Otherwise it may happen that you cannot start or stop the engine.