Aixro XR50, Руководство по эксплуатации

Страница: 20 / 23

© Aixro GmbH / Woelfle Engineering GmbH 19/23
8.5. Dripping Carburettor / Overflow
If the carburettor loses fuel at the top of the float bowl, the gasket of the float bowl may be
damaged. In this case remove the float bowl and replace the gasket.
Fuel can also leak from the overflow lines. If these are leaking, they should also be replaced.
If fuel should especially escape through the overflow lines in curves, the float level may be
too high, so the fuel supply to the carburettor is blocked too late. In this case reduce the float
level.
8.6. Engine Suddenly Lean
! If the engine suddenly develops a lean condition, or the idle speed is higher than nor-
mal, you should reduce the engine speed immediately and stop the engine as soon as
possible. Failure to do so could lead to excessive wear and engine damage from lack
of lubrication.
The most simple cause for this issue is a damage of the rubber carburettor connection.
Check it thoroughly for cracks, and replace it if any damage is visible.
! If you notice a crack or emersion of oil in the area of the eccentric shaft or the engine
housing, you should have the engine checked by an expert.