Aisle-Master Bendi, Руководство по эксплуатации

Страница: 10 / 28

When you travel with the truck loaded tilt the mast back and keep the load low.
This will help stabilize loads with an uneven weight distribution.
When you load at high elevations, tilt the load back far enough to seat it against
the front vertical faces of the forks or the load back rest (if fitted).
When you unload at high elevations, make sure you only use enough tilt to
place the load onto the rack or stack.
Retrieving a Load
The following steps outline the proper procedure to be followed when retrieving
a load.
The black arrows indicate the direction to turn the steering wheel and the
grey arrows indicate the truck drive and mast carrier/fork directions.
1. Drive straight down the middle of the aisle (item 1) [14] and slow down
when approaching the load (item 2) [14] .
2. For narrow aisles bear to the side of the aisle that is opposite to the load
(item 3)
[14] . Maintain a distance of approximately 150mm (6 inches)
between the side of the truck and the side of the aisle. For wider aisles
stay in the centre of the aisle
3. Centre the forks using the side shift.
Warning
If the forks or load jam or catch during a stacking operation, do not
attempt to free them by reaching through the mast. Failure to follow
this guideline can cause serious injury or death.
4. Drive forward until the centres of the front wheels are aligned with the
centre of the pallet/load to be lifted (item 4)
[14] , stop the truck and put
the direction lever into neutral.
5. Lift the forks to the required height and use the tilt to level the forks.
6. Turn the steering wheel/forks towards the load to be lifted (anticlockwise
for LHS). Stop turning when the fork nearest to the load (item 1)
[15] is
approximately 100mm (4 inches) from the face of the rack/stack.
7. Set the direction lever to reverse. Slowly reverse the truck and
simultaneously turn the steering wheel/forks towards the load
(anticlockwise for LHS) until the forks are aligned central to the sides of
the load/