ASSEMBLY INSTRUCTIONS
2. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct connector,
and run the ductwork to a roof or wall cap (not included). Using tape (not
included), secure all the ductwork connections so that they are air tight.
CONNECT ELECTRICAL WIRING
Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the wiring
plate. Refer to the wiring diagram, and connect the wires as shown.
SE80RVL
BLACK(BLK)
WHITE(WHT)
BLUE(BLU)
GROUND (GRD)
LIGHT
WIRE PANEL
UNIT
FAN
SE80RVLH
FAN
BLK
SWITCH
COM
WHT
SENSOR
BRN
SWITCH
BLK
WHT
LIGHT
BLU
SWITCH
WHT
SWITCH BOX
FAN
LIGHT
RECEPTACLE RECEPTACLE
POWER SUPPLY
120V AC
BLACK (BLK)
WHITE (WHT)
BLUE(BLU)
BROWN (BRN)
GROUND (GRD)
SENSOR
WIRE PANEL
UNIT
HUMIDITY
L
RECEPTACLE
T
LIGHT
Motor
N
H
FAN
LIGHT
FAN
LIGHT
BLK
LINE
WHT
IN GRD
SWITCH BOX
UNIT
SWITCH BOX
RECEPTACLE
RECEPTACLE
120V AC LINE IN
FINISH CEILING WORK
1. A circle ceiling hole (6 1/2 inches (165mm) dia.) shoule be cut. And
make sure there will be a gap (> 1/8 inches (3.2mm))between bottom
of fan body and ceiling.
Lamp base
Install the fluorescent lamp.
Note: The lamp base can adjust the height in 2.6 in. to 4 in. (66mm-102mm)
with the wing nut on both side of the lamp base.
Wing nut
Fluorescent lamp
Joist
Hanger bar
Ceiling
After finishing the ceiling job, fill gap between flange and ceiling with caulk or
other sealant to pervent air leakage.
REPLACEMENT INSTALLATION
1. Remove the trim ring by pulling down the springs.
2. Remove the screws as shown in the right.
3. Remove the lamp base.
4. Pull the duct system, so that you can see the blowe system.
Remove the screws
Blowe system
Lamp base
3
