PLAN THE INSTALLATION
1. Do not use in a cooking area.
2. Two ways to connect ductwork to a factory-shipped unit.
ROOF CAP *
ROUND
DUCT *
*Purchase
separately
ROUND
WALL
CAP *
ELBOW *
ASSEMBLY INSTRUCTIONS
1. Befor installation, you need to know:
Screw A
ST4.2*13mm
Screw B
ST4.2*25mm
Hanger bar
13 3/8 in (340mm)
(long)
14 3/8 in.-23 1/2 in. (365-597)
1. MOUNT WITH HANGER BARS
1a. Sliding hanger bars have been provided, which allow the housing to be
positioned accurately anywhere between the framing. The bars can be used
on all types of framing: I-joist, standard joist,
and truss construction. Slide hanger bars onto housing and adjust as
needed to fit between framing.
1b. Extend the hanger bars to the width of the framing. Position the
Screw A
ventilator with the hanger bar tabs wrapped around the bottom edge of the
framing, holding the ventilator in place.
Secure hanger bars to framing using one screw on each end of hanger bar.
Select a proper hole and secure the hanger bars together using flange
screws.
Screw B
2
