In case of to be connected to an AZXCCPC, Available modes will depend of installation type
configured in that element.
Installation type
Available mode
Aerothermal
Forced
Semi-forced
2 Pipes
Forced
Semi-forced
3-4 Pipes
Forced
Semi-forced
Free
Keep in mind that when you choose any mode of Heat air-conditioning, the systems you are
connected with will change to the same Heat mode or the available mode if the others are not.
This point applies to all imposition modes.
To set up the imposition mode of the SuperMaster Controller, you must access the configuration
mode and select the desired mode. By default, the Forced Mode is the one imposed. To be
modified, follow these steps:
Fig. 7
3.4.2. Set-point temperature range
The SuperMaster controller allows configuring the set-point temperatures range for both cooling
and heating mode. To do this, do as follows (Fig. 8):
1)
Access the configuration menu from user mode by long press on
.
2)
Use the selection arrows up or down
until you see
on the screen.
3)
Press on
to confirm the access.
4)
Use the selection arrows
up or down to select
and press to confirm on
,
showing the screen
again.
Fig. 8
29
