3.2. Assemble and connection
3.2.1. Assemble
SuperMaster controller is available in wall-mounted (Fig. 1) or wall-embedded (Fig. 2)
assemble.
To fit it, do as follow:
Separate
wall-support from thermostat.
Fix wall-support either directly on the wall or on a wall-embedded mechanism box
pulling out the cable through the hole designed for it.
Mount on the wall support the back protection case of the controller pulling out the
cable through the hole designed for it.
Once connection is done, assemble display on the back protection case (Fig. 1).
Embedded SuperMaster controller is designed for a screwed wall-embedded box of size
100x100. Compatible brands are:
-
Solera 362 (100x100 mm)
-
Jangar 2174 (100x100 mm)
-
IDE CT110 (100x100 mm)
-
Fematel CT35 (100x100 mm)
Note:
Dry-wall embedded boxes are not compatible with embedded controller from Airzone.
To fit a wall-embedded controller (Fig. 2) do as follows:
Remove the trim-frame of the set.
After connecting the wire, use the washer and screws to fit it to the wall-embedded box.
Place trim-frame ensuring that it is correctly fit.
Fig.
1
Fig.
2
25
