Airwell PAC BT Series, Инструкция по установке и эксплуатации

Страница: 28 / 112

26
5.7 INDOOR UNIT CONNECTION
The holes for passing the electric lines are on the upper part
of the unit.

Remove the protection cover of the hole selected.

Insert the connection cable.

Pass the cable betwe and insert it behind the electrical
panel. (see figure)

Connect the cable to the main isolator switch.
Isolator switch
Connect the line to the main isolator switch inside the
electrical panel.
The minimum section is calculated using a cable type FG7(0)
R 0,6/1 KV .
It is used a different type of cable, the section must be
recalculated by the designer of the electrical system.

Make a hole in the fair lead and insert the cable.

Carry out the connection in accordance with the
electric connection layout .
5 - ELECTRICAL CONNECTIONS
5.8 OUTDOOR UNIT CONNECTIONS
1
Power connections inlet
1
Power connections inlet
2
Outdoor unit connections outlet
Terminal block of the customer connections
Max.24v AC 5A / AC1
ALM (alarm signal)
Used for connecting a visual unit blocked signal device
value description
0 =
input disabled
1 =
Remote ON-OFF input
2 =
Remote mode change input (hot/cold)
3 =
remote system call input
4 =
second remote system set point
Digital input configuration (password protected)
Configuration parameters
parameter
39 ConfigF-DI1
parameter
40 ConfigF-DI2
Different configuration combinations are available using
inputs DI1 and DI2.
HP *
↳
settings
↳
parame-
ters
↳
configuration
D
I2
=
D
igit
al
inp
ut
1
2V
D
I1
=
D
igit
al
inp
ut
1
2V
XC-F
Remote ON/OFF
Enables the unit to be turned on remotely ( e.g. by a
thermostat or timer)
Remote mode change (hot/cold)
Enables the mode to be changed from heating to cooling by a
remote control unit.
The unit parameters are overwritten by RCW15 keyboard. Make the customization by using RCW15
*
1
2
ALM