Airstream GLOBETROTTER 2023, Руководство пользователя

Страница: 33 / 104

2023 Globetrotter
5-5
Interior
Ceiling and Directional Lighting
All lighting in the Airstream trailer is LED and most will
require a replacement fixture should it go out. The main
ceiling lights can be turned on/off or dimmed by the
switch at the entry door. Some light fixtures may have
a push button switch located on the fixture. Gently
squeezing the lens in the middle and pulling down
will remove the lens� The bed and lounge areas have
individually switched directional lighting�
Storage Tips
Galley cabinets should have the heaviest items stored
on the bottom and lighter items overhead� After loading,
put skillets and canned goods on the floor or bottom
shelf, and cereals and crackers in the overhead roof
locker� Use unbreakable-type plates and saucers, and
consider storing your dish towels around them� The
galley sink cover and trash bin covers can be stored in
the galley’s roof locker and drawer respectively�
Clothes hung in wardrobes should be kept on hangers
that snap over the clothes rods to keep them from
bouncing off on rough roads� Try to avoid large bulky
coats� Layers of lighter clothing will usually keep you
warmer, are more versatile, and are easier to store�
WARNING
Keep flammable material away from the furnace.
4� Align the tabletop sockets with the legs and push
down on the tops until seated on the legs�
5� Once mounted, join the two halves together by
lining up the latches on the underside of the
tabletops and latch them into place�
To convert to a U-shaped dinette, remove the rear table
and pedestal leg� Pull the two drawers out and place
the provided seat cushion directly on top of the drawers
to bridge the gap, using the drawers as a base�
To convert the dinette to a bed, remove the center
seat cushion, close the drawers, and place the rear
tabletop across the gap between the seats� Insert
the forward tabletop across the gap and latch the two
halves together to form the bed base� There are rubber
stoppers on the bottom of the tabletops to keep them
in place� Position the provided cushions across the
tabletop to complete the conversion�
Both the 25FB and 27FB have a sofa bed pullout for
additional sleeping capacity� Pull the sofa bed out and
place the additional provided cushions on the platform
to complete the bed�
30RB Model
Use the following steps to set up the various dinette
and bed layouts�
Dinette:
1�
Pull the round center covers off each floor base.
2� Find the T-bolts on the bottom of each leg and turn
them counterclockwise until extended�
3� Align and insert the T-bolts into the rectangular
openings in each floor base. Twist the legs
clockwise and tighten until snug�
4� Align the tabletop sockets with the legs and push
down on the top until it is seated on the legs�
To convert the 30RB dinette to bed lift the tabletop
up and off the legs� Remove the dinette legs and
store them� Replace them with the shorter bed legs
found in the wardrobe using steps 2-4 above� Lay the
provided cushions across the tabletop to complete the
conversion�
The 30RB also has a sofa bed pullout for additional
sleeping capacity� Pull the sofa bed out and place the
provided cushions on the platform to complete the bed�