Airspan AS3010, Руководство по вводу в эксплуатацию

Страница: 68 / 580

I ni ti al Con fi gu r atio n C o m m i ssi o n i n g M an u al
3.1. Overview
Before you can manage the ASWipLL devices (BSR, SPR, and BSDU) using the
ASWipLL network management system (i.e. WipManage), you need to define
certain initial network, management, and radio frequency (RF) parameters. These
initial configuration parameters include the following:
IP address (of BSR, SPR, and BSDU)
Subnet address (of BSR, SPR, and BSDU)
SPR's index number in the BSR
BSR's Air MAC address
Frequency table ID (for BSR-SPR wireless communication)
After you initialize the ASWipLL devices with these configuration parameters, you
can manage them remotely using WipManage or WipConfig through an IP network
connection.
Initial configuration is performed using ASWipLL’s WipConfig program (or the
WipConfig PDA application, which runs on a Personal Digital Assistance device --
refer to the WipConfig PDA User's Guide ). The initial configuration is performed
through a serial communication mode by connecting the ASWipLL device to the
serial port (i.e. COM) of the PC running WipConfig.
In general, to successfully establish an air and a network link between the BSR and
SPRs, you must ensure the following:
Correct IP and subnet addresses are configured (according to your network's
addressing scheme)
Same frequency table ID is configured for the BSR and the SPRs
Same maximum transmission rate mode is configured for the BSR and SPRs
Correct BSR's Air MAC address is configured for the BSR
Correct BSR's Air MAC address is assigned to the SPR
3-2 Airspan Networks Inc. 01040311-07