AirHarmony-4400 (External Cavity Filters) Installation Guide
UGD-D01186
Airspan Commercial and Internal Use
4
Son installation requiert une formation spécifique du personnel. L’AirHarmony-4400, radio
et antenne doit être installe UNIQUEMENT par des installateurs professionnels
expérimentés et ayant une connaissance des constructions locales et règles de sécurité, ainsi
que, dès que nécessaire, disposant d’un agreement des autorités gouvernementales de
régulation. Toute enfreinte a ces obligations peut annuler la garantie délivrée par Airspan
pour ces produits et peut exposer l’utilisateur final ou le fournisseur de services a des
dommages légaux et financiers.
Airspan et ses revendeurs ou ses distributeurs ne sont pas responsables des blessures,
dommages ou violations de la régulation en vigueur lies a l’installation du système extérieur
ou des antennes.
L’Equipment doit être installe dans une zone a accès réduit et contrôle.
Parafoudres et Protections contre les surtensions transitoires doivent etre installés a
l’exterieur de l’équipement ITE sont tenus de se conformer aux exigences relatives aux
normes CEC/NEC concern
ées
Important Safety Instructions
Read and Save these instructions
This Installation Guide contains instructions and warnings that should be followed during
installation, and operation.
Failure to follow these instructions could cause bodily injury and/or product failure
Safety
1.
Read this guide and follow all operating and safety instructions.
2.
Static sensitive components inside - do not remove the lid or base: No user serviceable
parts inside.
3.
The ground connection should be made before connecting to supply connections.
4.
Position the power cord to avoid possible damage; do not overload circuits.
5.
Do not place this product on or near a direct heat source, and avoid placing objects on
the terminal.
6.
To avoid electrical shock do not install this device during adverse conditions such as rain
or inclement weather.
7.
Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners. Disconnect the
power before cleaning.
8.
The units should not be located too near power lines or other electrical power circuits,
where it can come into contact with such power lines or circuits.
9.
The radio transceiver must be properly grounded to protect against power surges and
accumulated static electricity. It is the user’s responsibility to install this device in
accordance with the local electrical codes.
10.
Installation of the AirHarmony-4400 must be contracted to a professional installer.
11.
The circuit breaker should be easily accessible in case you have to disconnect the device.
12.
When installed in the final configuration, the product must comply with the applicable
Safety Standards and regulatory requirements of the country in which it is installed. If
necessary, consult with the appropriate regulatory agencies and inspection authorities
to ensure compliance.
