AirSep AS-Q, Инструкция по эксплуатации, Страница: 44 / 198

44 AS-Q—AS-Z Series Instruction Manual
AirSep Corporation
The oxygen generator will not produce oxygen during a normal
start-up until the OXYGEN RECEIVER PRESSURE gauge
registers pressure less than the minimum pressure specified in this
instruction manual.
Start the flow of oxygen from the oxygen receiver to your application.
6.6 EXTENDED SHUTDOWN
To shutdown the oxygen generator for 24 hours or longer, complete all the steps in
Section 6.4 — Shutdown. In addition, perform the following steps:
1. Fully close all manual valves on the oxygen receiver to isolate the
oxygen in the oxygen receiver, to prevent the loss of pressure in the
oxygen receiver and enable a normal start-up.
2. Disconnect the power supply.
6.7 START-UP AFTER AN EXTENDED SHUTDOWN
After an extended shutdown or an unexpected shutdown, such as a loss of electrical
power, you must purge the oxygen receiver of any low concentration oxygen before
the oxygen generator can supply oxygen within concentration specifications. To
purge the oxygen receiver, follow all the steps in Section 6.2 — Initial Start-Up.
Using the oxygen generator at flows higher than 15% above those
specified in Appendix A of this manual, will result in the likely
contamination of the molecular sieve beds. This damage is not
covered under the standard warranty.